Seat ALHAMBRA Owner's Manual page 344

342 If and when
Note
The vehicle can only be towed if the electronic parking brake and steering
lock are deactivated. If the vehicle has no power supply or there is an elec-
tric system fault, the engine must be started using jump leads to deactivate
the electronic parking brake and electronic steering lock.
Fitting the front tow ring
The location for the removable tow ring is on the right-hand side of the front
⇒ f ig.
bumper 218.
The towing eye should always be kept in the vehicle.
Note the instructions for towing ⇒ p age 341.
To fit the tow ring
● Take the tow ring from the vehicle tool kit ⇒ p age 320.
● Press on the upper cover and carefully remove it forwards. Allow the cov-
er to hang.
● Screw in the tow ring into its position anticlockwise as far as it will go
⇒ f ig. 218
tion.
● After towing, remove the tow ring by turning it clockwise and put the
cover back in place.

CAUTION
The tow ring must always be completely and firmly tightened. Otherwise, it
could be released while towing and tow-starting.
Fitting the rear tow ring
Fig. 218 On the right-
hand side of the front
bumper: Screw in the
towing ring.
The location for the removable tow ring is on the right-hand side of the rear
bumper
no fitting behind the cover to insert the tow ring. For towing, fit and use the
trailer hitch ⇒ p age 233, ⇒ .
Note the instructions for towing ⇒ p age 341.
⇒ . Use a suitable tool to firmly tighten the tow ring in its loca-
⇒ f ig.
219. For vehicles with a factory fitted trailer system, there is

Fig. 219 On the rear
bumper, to the right hand
side: Tow ring in position.
