Seat ALHAMBRA Owner's Manual page 19

WARNING (Continued)
● If the fabric or other parts of the seat belt are damaged, the seat belts
could break in the event of an accident or sudden braking.
● Always have damaged seatbelts replaced immediately by seat belts
approved for the vehicle in question by SEAT. Seat belts which have been
worn in an accident and stretched must be replaced by a specialised
workshop. Renewal may be necessary even if there is no apparent dam-
age. The belt anchorage should also be checked.
● Never attempt to repair, modify or remove a seat belt yourself. All re-
pairs to seat belts, retractors and buckles must be carried out by a spe-
cialist workshop.
Warning lamp
Safety First
Fig. 3 Warning lamp on
the instrument panel
Operating instructions

Lights up
or flash- Possible cause
es
Driver's seat belt not fas-
tened or front passenger's

seat belt not fastened if the
front passenger's seat is oc-
cupied.
Objects on the front passeng-

er's seat.
Some control and warning lamps on the instrument panel will come on to
check certain functions when the ignition is switched on. They will switch off
after a few seconds.
A signal will be heard for a maximum of 90 seconds if the seat belts are not
fastened as the car drives off and reaches a speed of more then 25 km/h or
if the seat belts are unfastened while the vehicle is in motion. The seat belt
warning lamp  will also flash.
Practical tips
Seat belts
Fig. 4 Example of seat
belt status display for the
rear seats (here, a 7-seat
vehicle) on the instru-
ment panel. above the
second row and below
the third row of seats.
Solution
Fasten seat belts!
Remove any objects from the
front passenger's seat and store
them safely.

Technical Specifications
17