Seat ALHAMBRA Owner's Manual page 336

334 If and when
To change the bulb
To release the lamp holder, press on the attachment tabs
9.
⇒ f ig. 212
to
1
10. Remove the lamp holder from the tail light unit.
11. Replace the faulty bulb by a new identical bulb.
Place the lamp holder in the tail light unit. The attachment tabs
12.
should audibly click into place.
Insert the connector and press the red attachment strip in so that
13.
the connector is locked into place.
Assembling the tail light units
Complete operations only in the sequence given:
Rear light, left
Carefully insert the tail light unit into the opening in the bodywork.
14. To do this, insert the upper tail light unit guide into the attachment
Tighten the white attachment screw using the screwdriver from the
15.
in the direction of the arrow.
4
Rear light, right
ring.
on-board tools.
Rear light, left
Ensure that the tail light unit has been correctly fitted and is firmly
16.
secured.
Replace the cap and rotate it
1
17. 90° in the opposite direction of
the arrow.
18. Close the storage compartment.
Close the tailgate ⇒ p age 84.
19.
Rear light, right
Move the 12 V socket support
upwards gently until it is correct-
ly closed.
