Seat ALHAMBRA Owner's Manual page 332

330 If and when
To replace the xenon headlights bulb
There is no need to remove the headlight to replace bulbs.
Complete operations only in the sequence given:
1.
2.
3.
4.
5.
6.
Fig. 205 In the engine
compartment: Turn signal
cover.
7.
8.
Always seek the help of a specialist when changing the Xenon dipped beam
and full beam headlamps ⇒
Note
The illustrations show the left hand headlight. The structure of the right
hand side headlight is symmetric.
Fig. 206 Turn signal in-
dicator lamp holder
1
and turning light .
2
Turn signal indicators
1
Always take the checklist into account and take the necessary ac-
tions ⇒ p age 327.
Open the bonnet  ⇒ p age 275.
⇒ f ig. 205
Rotate the cover in the direction of the arrow and remove
it.
Rotate the lamp holder
1
Press the wire clip downwards
⇒ f ig. 206
to the left all the way
and pull the lamp holder
and pull it out backwards with
⇒ f ig. 206
the bulb.
Depending on the model, the bulb is removed directly from the
lamp holder or it may need to be rotated and then removed.
Replace the faulty bulb by a new identical bulb.
Place the bulb holder in the Place the lamp holder in the
headlight and rotate to the right headlight and pull the wire clip
all the way. upwards until it clicks into place.
⇒ f ig. 205
Rotate the cover in the opposite direction to the arrow as
far as it will go.
in Introduction on page 326.
Turning lights
2
2
out with the bulb.
