Seat ALHAMBRA Owner's Manual page 224

Hide thumbs Also See for ALHAMBRA:
Table of Contents

Advertisement

222
Driving
Note
● Do not only rely on the tyre monitoring system. Regularly check your
tyres to ensure that the tyre pressure is correct and that the tyres are not
damaged due to puncture, cuts, tears and impacts/dents. Remove objects
from the tyres only when the tyres have not been pierced by these.
● The tyre monitoring system is set to the tyre pressure recommended by
the manufacturer and indicated on the label
Elements of the tyre monitoring indicator
Tyre monitoring indicator with button.
See ⇒  p age 223.
 Warning lamp  on the instrument panel.
button on the centre console.
SET
 Monitoring the tread of all tyres using ABS sensors (indirect measure-
ment).
 Adjustable medium and full-load tyre pressures.
 Button to update the system when the tyre pressure is changed.
⇒  f ig.
176.
Control lamp
Lights
Possible cause ⇒ 
up or
flashes
The tyre pressure of a wheel
has dropped considerably in
relation to the pressure set by
the driver ⇒  p age 223.
System malfunction.
Several warning and control lamps should light up for a few seconds when
the ignition is switched. This signals that the lamp is working properly. They
will switch off after a few seconds.
WARNING
When the tyres are inflated at different pressures or at a pressure that is
too low then a tyre may the damaged resulting in a loss of control of the
vehicle and a serious or mortal accident.
● If the indicator  lights, stop immediately and check the tyres.
● If the tyres are inflated at different pressures or if a tyre pressure is
too low, this will increase tyre wear, negatively affecting vehicle stability
and increasing braking distances.
Solution
 Stop the vehicle! Reduce your
speed immediately! Stop the ve-
hicle safely as soon as possible.
Avoid sudden manoeuvres and
braking!
Check all tyres and pressures.
Replace any damaged tyres.
Consult a specialist workshop if
the tyre pressure is correct and
the lamp remains lit after
switching the ignition off and
back on again. Have the system
checked there.

Advertisement

Table of Contents
loading

Table of Contents