Complete Power Supply Replacement; Replace Power Canister (60-Drive); Prepare To Replace Power Canister - Fujitsu ETERNUS AB Series Maintaining Hardware

Attention: Do not use excessive force when sliding the power supply into the system; you can
damage the connector.
3. Close the cam handle so that the latch clicks into the locked position and the power supply is fully seated.
4. Reconnect the power supply cabling:
a) Reconnect the power cord to the power supply and the power source.
b) Secure the power cord to the power supply using the power cord retainer.
5. Turn on the power to the new power-fan canister.
What to do next
Go to Complete power supply

Complete power supply replacement

You complete the power supply replacement by confirming that the new power supply (referred to in
SANtricity System Manager as a power-fan canister) is working correctly. Then, you can gather support data
and resume normal operations.
Procedure
1. On the new power supply, check that the green Power LED is on and the amber Attention LED is OFF.
2. From the Recovery Guru in SANtricity System Manager, select Recheck to ensure the problem has been
resolved.
3. If a failed power supply is still being reported, repeat the steps in
power supply. If the problem continues to persist, contact technical support.
4. Remove the antistatic protection.
5. Collect support data for your storage array using SANtricity System Manager.
a. Select Support > Support Center > Diagnostics.
b. Select Collect Support Data.
c. Click Collect.
The file is saved in the Downloads folder for your browser with the name support-data.7z.
6. Return the failed part to Fujitsu, as described in the RMA instructions shipped with the kit.
Results
Your power supply replacement is complete. You can resume normal operations.

Replace power canister (60-drive)

Each 60-drive controller shelf or drive shelf includes two power canisters for power redundancy. If a power
canister fails, you must replace it as soon as possible to ensure that the shelf has a redundant power source.
Related concepts
Power canister overview
Requirements for replacing a power canister

Prepare to replace power canister

You prepare to replace a power canister in a 60-drive controller shelf or drive shelf by collecting support data
about your storage array and locating the failed component.
Before you begin
• You have reviewed the details in the Recovery Guru to confirm that there is an issue with a battery and to
ensure no other items must be addressed first.
• You have checked that the amber Attention LED on the power canister is on, indicating that the canister
has a fault. Contact technical support for assistance if both power canisters in the shelf have their amber
Attention LEDs on.
replacement.
on page 28
on page 30
Remove power supply and
| Canisters |
Install new
34