Procedure
1. Using a #1 Phillips screwdriver, remove the screws that attach the HIC faceplate to the controller canister.
There are four screws: one on the top, one on the side, and two on the front.
2. Remove the HIC faceplate.
3. Using your fingers or a Phillips screwdriver, loosen the three thumbscrews that secure the HIC to the
controller card.
4. Carefully detach the HIC from the controller card by lifting the card up and sliding it back.
Attention: Be careful not to scratch or bump the components on the bottom of the HIC or on the
top of the controller card.
Host interface card (HIC)
5. Place the HIC on a static-free surface.
Thumbscrews
| Controllers |
21