Complete Fan Canister Replacement - Fujitsu ETERNUS AB Series Maintaining Hardware

Handle to pull the fan canister out.
4. Slide the replacement fan canister all the way into the shelf, and then move the fan canister handle until it
latches with the orange tab.
What to do next
Go to Complete fan canister

Complete fan canister replacement

You complete the fan canister replacement by confirming that the new fan canister is working correctly. Then,
you can gather support data and resume normal operations.
Procedure
1. Check the amber Attention LED on the new fan canister.
Note: After you replace the fan canister, the Attention LED stays on (solid amber) while the firmware
checks that the fan canister was installed correctly. The LED goes off after this process is complete.
2. From the Recovery Guru in SANtricity System Manager, select Recheck to ensure the problem has been
resolved.
3. If a failed fan canister is still being reported, repeat the steps in
one. If the problem persists, contact technical support.
4. Remove the antistatic protection.
5. Collect support data for your storage array using SANtricity System Manager.
a. Select Support > Support Center > Diagnostics.
b. Select Collect Support Data.
c. Click Collect.
The file is saved in the Downloads folder for your browser with the name support-data.7z.
6. Return the failed part to Fujitsu, as described in the RMA instructions shipped with the kit.
Results
Your fan canister replacement is complete. You can resume normal operations.
replacement.
Remove failed fan canister and install new
| Canisters |
40