Fujitsu ETERNUS AB Series Maintaining Hardware page 87

Host interface card (HIC)
7. Hand-tighten the HIC thumbscrews.
Do not use a screwdriver, or you might over-tighten the screws.
8. Using a #1 Phillips screwdriver, attach the new HIC faceplate to the controller canister with the four screws
you removed previously.
What to do next
Go to Reinstall controller canister.
Reinstall controller canister
After installing the host interface card (HIC), you reinstall the controller canister into the controller shelf.
Procedure
1. Turn the controller canister over, so that the removable cover faces down.
2. With the cam handle in the open position, slide the controller canister all the way into the controller shelf.
The following figure is an example of an HB5100 controller shelf:
Thumbscrews
| Host interface cards |
87