Fujitsu ETERNUS AB Series Maintaining Hardware page 24

Host interface card (HIC)
4. Hand-tighten the HIC thumbscrews.
Do not use a screwdriver, or you might over tighten the screws.
5. Using a #1 Phillips screwdriver, attach the HIC faceplate you removed from the original controller canister
to the new controller canister with four screws.
What to do next
Go to Install new controller canister
Install new controller canister (duplex)
After installing the battery and the host interface card (HIC), if one was initially installed, you can install the
new controller canister into the controller shelf.
Thumbscrews
(duplex).
| Controllers |
24