Remove Failed Power Canister; Install New Power Canister - Fujitsu ETERNUS AB Series Maintaining Hardware

Attention LED. If it is Solid amber, the power canister has a fault, or there is no input power to
this power canister, but the other power canister is operating.
What to do next
Go to Remove failed power

Remove failed power canister

You remove a failed power canister so you can replace it with a new one. When you remove a power canister,
you turn off power, disconnect the power cord, and slide the component out of the shelf.
Before you begin
• You have one power canister that is installed and running.
• You have an ESD wristband, or you have taken other antistatic precautions.
Procedure
1. Put on antistatic protection.
2. Unpack the new power canister, and set it on a level surface near the shelf.
Save all packing materials for use when returning the failed power canister.
3. Turn off the power switch on the power canister that you need to remove.
4. Open the power cord retainer of the power canister that you need to remove, and then unplug the power
cord from the power canister.
5. Press the orange latch on the power canister cam handle, and then open the cam handle to fully release
the power canister from the mid plane.
6. Use the cam handle to slide the power canister out of the shelf.
Attention: When removing a power canister, always use two hands to support its weight.
What to do next
Go to Install new power

Install new power canister

You install a new power canister to replace the failed one. When you install a power canister, you slide the
component into the shelf, close the cam handle, reconnect the power cord, and reapply power.
Before you begin
• You have a replacement power canister that is supported for your controller shelf or drive shelf model.
• You have checked that the on/off switch of the new power canister is in the Off position.
Procedure
1. Using both hands, support and align the edges of the power canister with the opening in the system
chassis, and then gently push the power canister into the chassis using the cam handle until it locks into
place.
Attention: Do not use excessive force when sliding the power canister into the system; you can
damage the connector.
2. Close the cam handle so that the latch clicks into the locked position and the power canister is fully seated.
3. Reconnect the power cord to the power canister, and secure the power cord to the power canister using the
power cord retainer.
4. Turn on the power to the new power canister.
canister.
canister.
| Canisters |
36