LifeSpan DT7 Quick Start page 2

FITNESS
Time Dist Steps Cal Speed
Scan Bluetooth
PROBLEM:
The console is erratic or not
lighting up.
SOLUTION:
Check to make sure the treadmill
desk is properly plugged in. Turn
the power switch off and back on
again and make sure the Safety
Key is in place. Make sure the
connectors located in the front
of the treadmill and under the
desktop are fully plugged in. If the
problem persists contact LifeSpan
Customer Service.
Customer Service: 877.654.3837 x 4
TROUBLESHOOTING
DT7 TREADMILL DESK
Time Dist Steps Cal Speed
dc6
Scan Bluetooth
PROBLEM:
"UART" or "dc-6" appears in the
display.
SOLUTION:
Turn the treadmill desk power
switch off. Unplug the power cord.
Disconnect the 9 pin data cable,
then reconnect it. Make sure
the thumb screws are properly
tightened. Plug in the power cord.
Turn the treadmill desk power
back on and check to see if it
functions properly.
Please see Owner's Manual section Maintenance and Tips for more information.
PROBLEM:
The desktop surface is not level.
SOLUTION:
Check to make sure the base
feet are on a level surface. Run
calibration by pressing and
holding the height adjustment
buttons simultaneously for three
seconds.
Time Dist Steps Cal Speed
E1
Scan Bluetooth
PROBLEM:
The treadmill motor seems
strained or E1 comes up after
several minutes of use.
SOLUTION:
This problem usually occurs when
there is too much friction building
between the treadmill belt and
deck. The best thing to do is turn
the treadmill off, lubricate the
running belt with 100% silicone
(non-aerosol), and turn the
treadmill back on. Test the unit.
If E1 still comes up after testing,
contact LifeSpan Customer Service.
lifespanfitness.com