DirectOut Technologies EXBOX.AES User Manual page 47

Issue
No signal at
the output
port.
No signal at
the output
port.
MADI signal
at the input is
not stable.
No transport
of serial data.
EXBOX.AES Manual - Version 2.0
CHAPTER 6: Troubleshooting and Maintenance
Possible
reason
Signal cable
defective.
Connectors of
the signal cable
are dirty.
Signal source is
defective
or
bad signal
condition (Jitter >
1 ns) - e.g. due to
exceeded length
or bad screening
attenuation of
signal cable.
Embedder not
active
or
wrong baud
rate
Solution
Exchange the signal cable.
Use an air supply to carefully
remove any dust.
Never use objects for
cleaning.
or
Exchange the signal cable.
Change the source
or
use appropriate cables.
Adjust embedder setting and
check the LEDs 'RX' and 'TX'.
page 47 of 60