English User's Manual
Here we list some frequently asked questions and answers relating to CReader
Question: System halts when reading data stream. What is the reason?
Answer: It may be caused by a slackened connector. Please turn off the CReader
6011/7001/7001F/8001/8011/8021/9081, firmly connect the connector, and
switch it on again.
Question: Screen of main unit flashes at engine ignition start.
Answer: Caused by electromagnetic disturbing, and this is normal phenomenon.
Question: There is no response when communicating with on-board computer.
Answer: Please confirm the proper voltage of power supply and check if the
throttle has been closed, the transmission is in the neutral position, and the water
is in proper temperature.
Question: Why are there so many fault codes?
Answer: Usually, it's caused by poor connection or fault circuit grounding.