Connection; Connect Creader 6011/7001/7001F/8001/8011/8021/9081; Settings - Launch CReader 6011 User Manual

LAUNCH

4. Connection

4.1 Connect CReader 6011/7001/7001F/8001/8011/8021/9081

1. Turn the ignition off.
2. Locate vehicle's DLC socket: It provides standard 16 pins and is generally
located on driver's side, about 12 inches away from the center of dashboard.
See Figure 2-2. If DLC is not equipped under dashboard, a label indicating its
position will be given. In case no DLC is found, please refer to Automobile
Repair Manual.
3. Plug one end of the diagnostic cable into the DB15 connector of CReader
6011/7001/7001F/8001/8011/8021/9081, and connect the other end of the
diagnostic cable into the vehicle's DLC.
4. Turn the ignition on. Engine can be off or running.
5. After finishing, the system will start initializing. After initialization, the system
will enter the main menu interface.
CAUTION: Don't connect or disconnect any test equipment with ignition on or engine
running.

4.2 Settings

Select [Settings] in the main menu and press [OK], the system will enter the
following screen:
CReader 6011/7001/7001F/8001/8011/8021/9081
Figure 4-1(for CReader 7001)
10
English User's Manual