Operation - Hilti TE 6-A36 Original Operating Instructions

6.2 Charging the battery
DANGER
Use only the Hilti batteries and Hilti chargers listed
under "Accessories".
6.2.1 Charging a new battery for the first time
Charge the battery fully before using it for the first
time.
6.2.2 Charging a previously used battery
Ensure that the outer surfaces of the battery are
clean and dry before inserting it in the corresponding
charger.
For information about charging, read the operating
instructions for the battery charger and section 2.10
"Li-ion battery charge status" of these operating in-
structions.
Li-ion batteries are ready for use at any time, even
when only partly charged. Charging progress is in-
dicated by the LED display (see charger operating
instructions).
6.3 Fitting the battery 2
CAUTION
Before fitting the battery, check that the power tool
is switched off and that the transport lock is engaged
(forward/reverse switch in the middle position). Use

7. Operation

CAUTION
In the event of the drill bit sticking, the power tool
will pivot about its own axis. Always use the power
tool with the side handle fitted and hold it securely
with both hands so that the resulting opposing force
causes the slip clutch to release in the event of the
drill bit sticking. Use clamps or a vice to hold the
workpiece securely.
only the Hilti batteries intended for use with this
power tool, i.e. B 36/3.0 Li‑ion, B 36/2.4 Li‑ion,
B 36/2.6 Li‑ion, B 36/3.3 Li‑ion or B 36/3.9 Li‑ion.
1. Push the battery into the power tool from the rear
until it is heard to engage with a double click.
2. CAUTION A falling battery may present a risk of
injury to yourself or others.
Check that the battery is seated securely in the
power tool.
6.4 Removing the battery 3
1. Press both battery release buttons.
2. Pull the battery out of the power tool toward the
rear.
6.5 Fitting the side handle 4
1. Set the forward / reverse switch to the middle
position or remove the battery from the power
tool.
2. Release the side handle clamping band by turning
the handle counterclockwise.
3. Remove the depth gauge from the side handle in
order to avoid injury.
4. Slide the side handle clamping band over the
chuck and onto the cylindrical section at the front
end of the power tool.
5. Pivot the side handle into the desired position.
6. Fit the depth gauge and secure the side handle
in the desired position by turning the grip firmly
until tight.
7.1 Preparing for use
7.1.1 Fitting the insert tool 5
CAUTION
Wear protective gloves when changing the insert tool.
1. Set the forward / reverse switch to the middle
position or remove the battery from the power
tool.
2. Check that the connection end of the insert tool is
clean and lightly greased. Clean it and grease it if
necessary.
en
25