Hilti TE DRS6-A Original Operating Instructions
Rotary hammer, dust removal attachment
Hide thumbs
Also See for TE DRS6-A:
- Original operating instructions (236 pages) ,
- Original operating instructions (246 pages) ,
- Manual (252 pages)
Advertisement
Quick Links
Advertisement
Related Manuals for Hilti TE DRS6-A
Summary of Contents for Hilti TE DRS6-A
- Page 1 TE 6-A36 TE DRS6-A English Français Español Português...
- Page 9 TE 6-A36 TE DRS6-A Original operating instructions ........Mode d'emploi original .
- Page 10 1.3 Product information Hilti products are designed for professional use and may be operated, serviced and maintained only by trained, authorized personnel. This personnel must be informed of any particular hazards that may be encountered.
- Page 11 ▶ Write down the serial number in the table below. You will be required to state the product details when contacting Hilti Service or your local Hilti organization to enquire about the product. Product information Rotary hammer TE 6A36 Generation: Serial no.:...
- Page 12 ▶ Prevent unintentional starting. Ensure the switch is in the off‐position before connecting to power source and/or battery pack, picking up or carrying the tool. Carrying power tools with your finger on the switch or energising power tools that have the switch on invites accidents. ▶...
- Page 13 ▶ Observe the nationally applicable industrial safety regulations. ▶ To reduce the risk of injury, use only genuine Hilti accessories and accessory tools. Careful handling and use of batteries ▶ Observe the special guidelines applicable to the transport, storage and use of lithium-ion batteries.
- Page 14 For use where dust must be kept to an absolute minimum, Hilti offers the TE DRS-6-A (2) dust removal module and the DCD dust collection module as accessories.
-
Page 15: Operation
Note The use of unsuitable grease may cause damage to the tool. To reduce the risk of injury, use only genuine Hilti tools and accessories. Note After fitting the drill bit, grip it and pull it in order to check that it is securely engaged. - Page 16 ▶ Clean the dust shield on the chuck with a dry, clean cloth at regular intervals. ▶ Clean the sealing lip by wiping it carefully and then grease it again lightly with Hilti grease. ▶ It is essential that the dust shield is replaced if the sealing lip is damaged.
- Page 17 7 Troubleshooting ▶ If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by yourself, please contact Hilti Service. 7.1 The rotary hammer is not in working order Malfunction Possible cause...
- Page 18 8 TE DRS-6-A dust removal module (optional) The TE DRS6A dust removal module is an accessory for the Hilti TE 6A36 rotary hammer. It collects a high percentage of the dust generated and can be quickly and easily attached to the rotary hammer. The dust removal module is equipped with a suction fan.
- Page 19 2. Remove the depth gauge from the side handle. 3. Position the dust removal module on the guides and push it from the front onto the power tool until it engages. 4. After fitting the dust removal module, check that it is securely attached. 8.5 Setting the length (stroke) WARNING Risk of injury The telescopic section will jump out when the stroke preselection button is pressed.
- Page 20 Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The materials must be correctly separated before they can be recycled. In many countries, your old tools, machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative for further information.
- Page 21 Hilti = registered trademark of Hilti Corp., Schaan Pos. 3 | 20151222...