Leveling channels - If the enclosure is mounted on leveling channels, bond the channels to the woven wire mesh with
solid-steel wire jumpers of approximately the same gauge as the woven wire mesh. Bolt the enclosure to leveling channel,
front and rear.
Signal and power levels - Refer to section,
Cable Separation and
Routing, for guidelines.
Solid-bottom tray - Use steel solid bottom cable trays with steel covers for low-level signals most susceptible to noise.
Enclosure and Cable Tray Installation Guidelines
140
GEH-6721_Vol_I_BP
GEH-6721_Vol_I Mark VIe and Mark VIeS Control Systems Volume I
Public Information