GE Mark VIe System Manual page 8

Control System Warnings
Warning
Warning
Warning
Warning
Warning
8 GEH-6721_Vol_I_BP
To prevent personal injury or damage to equipment, follow all equipment safety
procedures, Lockout Tagout (LOTO), and site safety procedures as indicated by
Employee Health and Safety (EHS) guidelines.
This equipment contains a potential hazard of electric shock, burn, or death. Only
personnel who are adequately trained and thoroughly familiar with the equipment
and the instructions should install, operate, or maintain this equipment.
Isolation of test equipment from the equipment under test presents potential electrical
hazards. If the test equipment cannot be grounded to the equipment under test, the
test equipment's case must be shielded to prevent contact by personnel.
To minimize hazard of electrical shock or burn, approved grounding practices and
procedures must be strictly followed.
To prevent personal injury or equipment damage caused by equipment malfunction,
only adequately trained personnel should modify any programmable machine.
Always ensure that applicable standards and regulations are followed and only
properly certified equipment is used as a critical component of a safety system. Never
assume that the Human-machine Interface (HMI) or the operator will close a safety
critical control loop.
GEH-6721_Vol_I Mark VIe and Mark VIeS Control Systems Volume I
Public Information