Advertisement
Step 13:
-
On the front of the machine run
the Support Drive motor in reverse
-
Select High Heat if needed
-
Use Needle Nose pliers to remove
any material in and around the
feed tube
-
In the first picture to the right
circled in red is an example of
some material that needs to be
removed with pliers
Step 14:
-
Reattach the motor and Feed
Funnel
-
Cut approximately 5 inches of
support material
-
Select Run Support Motor forward
from the front of the machine
-
The Support Material should start
to extrude from the Support Tip
within 10 seconds
-
If no material extrudes repeat the
previous steps
Advertisement
