Advertisement
Step 5:
-
Unscrew the two motor screws
th
with a 7/64
allen
Step 6:
-
Remove the motor with the pliers
and let it hang
Step 7:
-
Using the needle nose pliers,
remove any excess material that is
in and around the tube that feeds
into the head
-
On the front of the machine, select
the appropriate drive motor and
select reverse to run the motor,
then select "High Heat" on the
front of the machine. This will
soften the material and help force
it back out of the tube.
-
This step could take a few minutes
as you will probably have to
remove some material, wait for
more to bubble out, and remove
more.
-
Repeat this until as much of the
material as possible is removed
Advertisement
