Advertisement
from the tube
Step 8:
-
With the brush included in the
Welcome Kit, brush any material
away from the drive wheel on the
motor
Step 9:
-
Reattach the drive motor to the
head
-
The pegs on the motor (circled in
red) line up with the holes on the
head (circle in red)
-
Another way to do this is to line up
the drive wheel with the tube that
the material was removed from
(next picture with the other drive
motor removed to be able to see)
-
If you line these up then the pegs
will be in the correct position
Advertisement
