Functions, Codes And Symbols - ABB Relion 611 Series Engineering Manual

Section 1
Introduction
1.4.3
8
When the function starts, the START output is set to TRUE.
• This document assumes that the parameter setting visibility is "Advanced".

Functions, codes and symbols

All available functions are listed in the table. All of them may not be applicable to all
products.
Table 1: Functions included in the relays
Function
Protection
Three-phase non-directional
overcurrent protection, low stage,
instance 1
Three-phase non-directional
overcurrent protection, high stage,
instance 1
Three-phase non-directional
overcurrent protection, high stage,
instance 2
Three-phase non-directional
overcurrent protection, instantaneous
stage, instance 1
Non-directional earth-fault protection,
low stage, instance 1
Non-directional earth-fault protection,
low stage, instance 2
Non-directional earth-fault protection,
high stage, instance 1
Non-directional earth-fault protection,
instantaneous stage
Three-phase directional overcurrent
protection, low stage, instance 1
Three-phase directional overcurrent
protection, low stage, instance 2
Three-phase directional overcurrent
protection, high stage, instance 1
Directional earth-fault protection, low
stage, instance 1
Directional earth-fault protection, low
stage, instance 2
Directional earth-fault protection, high
stage
Transient/intermittent earth-fault
protection
Non-directional (cross-country) earth
fault protection, using calculated Io
Negative-sequence overcurrent
protection, instance 1
Table continues on next page
IEC 61850 IEC 60617
PHLPTOC1 3I> (1)
PHHPTOC1 3I>> (1)
PHHPTOC2 3I>> (2)
PHIPTOC1 3I>>> (1)
EFLPTOC1 Io> (1)
EFLPTOC2 Io> (2)
EFHPTOC1 Io>> (1)
EFIPTOC1 Io>>>
DPHLPDOC1 3I> -> (1)
DPHLPDOC2 3I> -> (2)
DPHHPDOC1 3I>> -> (1)
DEFLPDEF1 Io> -> (1)
DEFLPDEF2 Io> -> (2)
DEFHPDEF1 Io>> ->
INTRPTEF1 Io> -> IEF
EFHPTOC1 Io>> (1)
NSPTOC1 I2> (1)
1MRS241255 B
IEC-ANSI
51P-1 (1)
51P-2 (1)
51P-2 (2)
50P/51P (1)
51N-1 (1)
51N-1 (2)
51N-2 (1)
50N/51N
67-1(1)
67-1(2)
67-2(1)
67N-1 (1)
67N-1 (2)
67N-2
67NIEF
51N-2 (1)
46 (1)
611 series
Engineering Manual