3.6
Adjusting the turnbuckle
A
Figure 3.8
Adjusting the parallel adjustment screw is done when the harrow is lowered into the work position
in the field. Check that the harrow is parallel with the ground while driving.
Adjust longitudinal inclination of the centre section by adjusting the parallel adjustment screw A.
! The front is lowered when turning the parallel adjustment screw clockwise. See position B.
! The front is raised when turning the parallel adjustment screw counter-clockwise. See position
C.
To enable later adjustment, ensure that the parallel adjustment screw always is properly greased.
11.07.2011
ver.2
NZA 500-1000 /T/ST
B
C
25