Adjusting The Following Harrow - Vaderstad NZ Aggressive NZA 600 Series Original Instructions Manual

Instructions and adjustments

3.12 Adjusting the following harrow

Figure 3.25
The following harrow is spring-loaded and features a release mechanism to prevent damage on the
implement when reversing.
The working depth and angle of the tines can be easily adjusted. The harrow should be in the raised
position when making this adjustment.
Adjust the working angle by moving the cotter pin A in the series of holes B.
Adjust the working depth by using the cranks C. Set all the cranks to the same length.
34
C
B
A
11.07.2011
ver. 2