Table of Contents
Advertisement
Instructions and adjustments
3.2
Height adjustment of the towing eyelet
A
Figure 3.4
The towing eyelet of the implement can be set at different heights to suit the different towing
heights of the tractor. When the implement is in the work position on a hard surface, and the lifting
ram of the transport wheels is at the end stop, the frame should be parallel with the ground. When
properly adjusted, the distance from ground to the lower edge of the hitching connector should be
approx. 325 mm. If necessary, adjust it by moving the towing eyelet in the hole series (A).
3.3
Adjusting the preimplement
Figure 3.5
The work depth/angle fo the preimplement can be adjusted as shown in "Figure 3.5".
18
14.04.2014
ver. 2
Advertisement
Table of Contents
