GRAPHTEC CS500 Series Service Manual page 26

4.2 Installing the Driver Software for Windows XP
The following procedure assumes that you are using the CS500-11 as part of your system, and that you are
using the USB interface. If you are using the IEEE 1394 interface, GRAPHTEC CS500-11 IEEE 1394 SBP2
Device will be displayed where CS500-11 is displayed when the USB interface is used. The scanner name
displayed in the windows is the name of the scanner connected to the computer (CS500-11 is used in this
section).
(1) Connect the scanner to the computer, turn on the scanner first, and then turn on the computer. When
Windows starts up, insert the CD-ROM supplied with the scanner in the CD-ROM drive. Turn on the
power to the scanner.
(2) Next, the Found New Hardware Wizard window appears.
Select the option "Install from a list or specific location (Advanced)".
(3) The screen shown below is displayed when you click Next.
Select the option "Search for the best driver in these locations" and select the check box entitled "Include
this location in the search".
Click Browse and select the DRIVER folder in the CD-ROM drive or enter a CD-ROM drive name and
\DRIVER using the keyboard.
Example: For drive E, enter "E:\DRIVER."
CS500/IS200-UM-251-9370 4-4
4. INSTALLING THE SOFTWARE