General Specifications; Safety Precautions; Installation; Controls - Labnet D0100 Instruction Manual

1.0 General Specifications

Temperature range
Temp. increments
Temp. uniformity
Temp. accuracy
Timer
Block
Block capacity
Dimensions (WxDxH)
Weight
Electrical
Electrical requirements:
100-240V, 50/60Hz, 0.7A – 30W Max

2.0 Safety Precautions:

- Do not use this product in an explosive environment
- Do not use in the presence of flammable or combustible material
- Do not heat substances that react violently when heated
- Do not touch area around block or block well when unit is hot.
- Do not spill liquids into the well area or into the unit
- Connect unit only to a properly grounded outlet
Caution: HOT Surfaces that can burn or cause injury.
Use of this product in any manner not specified by the manufacturer or modification of the product
may cause injury and/or may void the warranty.

3.0 Installation

Upon unpacking Mini Digital Dry Bath, inspect for damages. Shipping damage is the responsibility
of the carrier. Inspect that the following are present:
AccuBlock™ Mini with AccuRack™
Users manual
Switching Power Adapter
Line cord
Select a location that is dry and not subject to drafts or moving air from heating or air conditioning
vents, or air blown by other equipment. Place the unit on a flat, preferably non-flammable surface.
Allow sufficient room around the unit for access and cooling. Six inches minimum on all sides is
suggested. Plug the unit into a properly grounded outlet. Using the lifter, insert the block(s) into
the well. The unit is now ready for use.

4.0 Controls

LCD Display
Heat LED
Main Power Switch
START/STOP Switch Begins and ends the heating process
Mode Switch
Up Switch
Down Switch

5.0 Operation

1. Turn the unit on using the Main Power rocker switch on the rear of the unit.
2. The LCD will display a self test and the LED will turn on.
Ambient +5° to 100°C
0.1ºC
≤0.2ºC
≤0.2ºC
0 -19h:59m or continuous
Anodized Aluminum
12x 1.5mL tubes
5.5 x 4.8 x 2.4 in./14 x 12 x 6 cm
3 lb/1.3 kg
120V or 230V~, 50/60 Hz
(Block Temperature, Set Temperature, Timer)
(Heater Function)
Turns entire unit on and off.
Toggles the LCD display between Temperature and Timer Settings
Used to increment the set temperature.
Used to decrement the set temperature.