CARDIOSTRONG BX40 Owner's Manual page 5

STEP 2:
1. Install Handle Bar (3) on Console Mast (2) and lock with Quick Release lever (19).
In the mean time, get the Handpulse Wire (82)，Go through the console mast (2)
and use wire grommet (88) to fix the handpulse wire (82) in the mast (2).
2. Connect Computer Cable (80) and Hand Pulse Sensor Cable (82) to the Console
(48) and assemble on the Console Mast (2) using Phillips Head Screw Driver (43)
to tighten 4pcs of M5 × 12L Phillips Head Screws (41).
3. Use 13/ 15m/m Wrench (79) to install both Pedals (15 left and right) on the crank
axle. The left pedal is a reverse thread and will screw in a counterclockwise
direction. The pedals are marked with an R or L on the end of the threaded pedal
axle. Make sure to tighten the pedals firmly or a clicking noise can occur during
pedaling. It may be necessary to retighten the pedals after use if clicking occurs.
4. Take apart (M8 x 7T nuts and Ø8 × Ø20 × 1.5T flat washers (A)) under the seat (20).
Locate fixing frame mount under the seat and use 13/14m/m_Wrench (96)
tighten three M8 x 7T nuts and three Ø8 × Ø20 × 1.5Twashers. 【(A) attach to
under the seat【
14/15m/m_Wrench (79) to tighten under the seat and Nut.
5. Get the 1pcs of 3/8" × 1-1/2" Carriage Bolt (71) to go through Seat (20) and Inner
Slide (6) then tighten with 1pcs of Ø3/8" × Ø30 × 2T Flat Washers (72) and Brake
Tension Knob (52).
Get the Seat(20) to go through Sliding Seat Mount(7), Use
4
to