CARDIOSTRONG BX40 Owner's Manual page 4

Assembly Instructions
STEP 1:
1. Locate the Console Mast (2) and slide on the Console Mast Cover (60). Make sure
the cover is facing the correct direction, as shown below, before sliding onto mast.
Install the wiring harness (80) into the bottom of the mast and out the top. Be
careful when installing the console mast to the mainframe so as not to pinch or cut
the wiring harness, damage to the console may occur.
2. Install the console mast on the mainframe using the 6mm Allen Wrench (87) to
tighten 5pcs of 5/16" × 3/4" Socket Head Cap Bolts (32) , 4pcs of 5/16 Flat Washers
(33) , 5pcs of 5/16" Split Washers (35)and 1pcs of 5/16" Curved Washer (34). Snap
the Console Mast Cover (60) in place on the body of the bike.
3. Secure Front Stabilizer (4) and Rear Stabilizer (5) with 4pcs of 5/16" × 3/4" Socket
Head Cap Bolts (32), 4pcs of 5/16" Split Washers (35) and 4pcs of 5/16" Flat
Washers (33) by using 6mm Allen Wrench (87).
3