SeeMeCNC Rostock Max Assembly Manual page 5

1.4 - In the photo below I've got the first two feet installed – note that I initially inserted the
nylon fasteners incorrectly. The nuts should be on the _other_ side. Installing them as shown in the
photo will prevent the soft rubber caps from fitting properly.
1.5 - This is what the six feet should look like when installed in their proper location:
1.6 - The white caps just fit over the black plastic feet. Makes for a great non-slip assembly.
Rostock Max Assembly Guide
Figure 4 – First two feet mounted.
Figure 5 – All six mounted, with rubber caps installed.
5