Using Fieldbus Through An Rs485 Cable - Hyundai N800 Series Installation Manual

5.3.2 USING FIELDBUS THROUGH AN RS485 CABLE

1) Remove approximately 15 mm of the grey shield of the RS485
cable. Do this for the 2 fieldbus cables.
a) Strip the cables for approximately 5 mm to put them in the
terminals. Do not keep more than 10 mm of the cable
outside the terminals.
b) Strip the cable at such a distance from the terminal that you
can attach it to the frame with the cable clamp. Strip the cable
N800A
at a maximum length of 15 mm. Do not remove the aluminium
shield of the cable.
Table 28: RS485 cable data
Item
The plug type 2.5 ㎟
STP (shielded twisted pair), Belden 9841 or almost
The cable type
the same
So that it agrees with the fieldbus. See the fieldbus
The cable length
manual.
Desctiption
5. CONTROL UNIT
66