4. POWER CABLING
8) Cut the grommets open to move the cables through them.
a) Do not cut the grommet openings wider than what is
necessary for the cables that you use.
b) If the grommets fold in when you put the cable, pull the
cable back to make the grommets straight.
9) Attach the grommet and the cable so that the frame of the
drive goes into the groove of the grommet.
a) With the enclosure class IP54, the connection between
the grommet and the cable must be tight. Pull the first bit of the
cable out of the grommet so that it stays straight.
b) If this is not possible, make the connection tight with some in
sulation tape or a cable tie.
51
N800A