Blower Assembly; Spring (From Blower And Drive Kit) - Toro 78534 Operator's Manual

Figure 13
1. Bolt
2. Spacer
3. Locknut
4. Spring
2. Slide the blower assembly peg into the pivot
hole. For 60 inch mowers refer to Figure 14
and for 72 inch mowers refer toFigure 15.
Figure 14
60 inch Mower Deck

1. Blower assembly

2. Mower deck, 60 inch (152
cm) shown
5. Spring installed
6. Grass Deector
7. L end of spring, place
behind deck edge before
installing bolt
8. J hook end of spring
3. Pivot hole
4. Blower assembly peg
Figure 15
72 inch Mower Deck
1. Blower assembly
2. Mower deck, 72 inch (183
cm) shown
3. Close the blower assembly to see if the latches
are adjusted correctly. Loosen or tighten the
bolt so the latches firmly hold the blower
assembly against the mower deck , but can be
released by hand (Figure 16).
Figure 16
1. Latch
2. Bolt
4. Install the spring as shown in Figure 17.
12
3. Pivot hole
4. Blower assembly peg
3. Blower assembly