Checking And Adjusting The Blower; Latch; Greasing The Idler Arm; Inspecting The Bagger - Toro 78534 Operator's Manual

Figure 34
1. Idler pulley
2. Mower deck pulley
3. Spring
6. Install the spring as shown in Figure 35.
Figure 35
1. Spring loaded idler pulley
2. Short hook end
7. Pull back on the spring loaded idler pulley and
install the belt onto the spring loaded idler
pulley (Figure 34).
Checking and Adjusting the
Blower Latch
Close the blower assembly to see if the latches are
adjusted correctly. Loosen or tighten the bolts so
the latches firmly hold the blower assembly against
the mower deck , but can be released by hand.
4. Peg
5. Belt
6. Blower pulley
3. Long hook end
Figure 36

1. Latch

2. Bolt

Greasing the Idler Arm

Grease the bagger belt idler arm (Figure 37) every
50 hours.
Figure 37

Inspecting the Bagger

Inspect the bagger attachment after the first eight
hours of operation, and 100 hours thereafter.
1. Disengage the PTO, move the motion control
levers to the neutral locked position, and set
the parking brake.
2. Stop the engine, remove the key, and wait for
all moving parts to stop before leaving the
operating position.
26
3. Blower assembly