With Gas Engines; Upper Tube - Toro 78534 Operator's Manual

60 and 72in triple bagger for z500 series z master mowers

Hide thumbs Also See for 78534:

Table of Contents

Make sure the hooks are in the correct position.

Figure 17

1. Spring loaded idler pulley

2. Short hook end

5. Pull the spring loaded idler pulley back and

route the belt around the mower deck pulley.

Ensure the belt is routed around the blower

pulleys correctly (Figure 18).

Figure 18

1. Mower deck pulley

2. Spring loaded Idler pulley

3. Long hook end

3. Blower

Step

Sizing the Upper Tube for

60 inch Mowers with Gas

Engines

Parts needed for this step:

Procedure

Note: This procedure is for 60 inch mowers with

gas engines only.

1. Measure up 3–1/2 inches (89 mm) from

the bottom of the upper tube. Use the

existing 3 holes as marks and then mark it in

several places to create a line around the tube

(Figure 19).

2. Cut the 3–1/2 inches (89 mm) off the upper

tube (Figure 19).

Note: Notice the three indentations in the

tube. This is where holes will be drilled in the

following procedure.

Table of Contents

78535