Installing The Blower Assembly; Installing The Bagger Belt And Idler Spring - Toro TURBO FORCE Operator's Manual

Step
9
Parts needed for this step:
1 Blower assembly

Installing the Blower Assembly

Important
Make sure the mounting plate is installed
to the mower.
1. Move the grass deflector into the upright position.
2. Slide the blower assembly peg into the hole on the
bracket (Fig. 18).
2
3
Figure 18
1. Mower deck
2. Blower assembly
3. Blower assembly peg
3. Close the blower assembly. (Fig. 21).
4. Check if the latch fully engages the front latch peg.
Refer to Checking and Adjusting the Blower Latch on
page 24.
Note: There needs to be a little or no gap between the
blower assembly and the mounting plate.
1
5
4
m–7006
4. Mounting plate hole
5. Mounting plate
14
Step
10
Parts needed for this step:
1 Blower belt cover
1 Idler spring
1 Bagger belt
1 Pulley cover
Installing the Bagger Belt and
Idler Spring
Important
The idler spring and bagger belt need to be
installed together.
This will create slight tension on both the spring and belt
while installing them.
1. Check that the blower assembly is closed and ensure
the blower front latch is engaged on the front peg.
2. Slide the spring into the blower eyebolt (Fig. 19).
3. Install the spring into the idler arm eyebolt (Fig. 19).
5
3
1
Figure 19
1. Idler spring
2. Blower assembly
3. Idler arm eyebolt
4
2
m–6276
4. Blower eyebolt
5. Idler arm