Hanil Ultra 5.0 Quick Manual

Quick Guide
Display & Control Panel
LED Display
Status of RPM / RCF / Time / Temperature /
Rotor ID / Program / ACC / DEC
Setting Time
Up to < 100 hr, Continuous run (00:00)
5 0 0 0 0
1 9
Program Save / Call Setting Speed
Saving a program Setting RPM
(up to 100) Setting RCF
Calling up a program
Setting Run Parameters
(RPM / RCF / Time / Temperature / ACC / DEC)
Press a parameter Enter the desired values
to be changed on the keypad
Setting Rotor ID
After loading the rotor,
press the Rotor ID. button to identify the rotor.
(If identification fails, enter the rotor Id. manually.)
Ultra 5.0
Cat. No. : UL-5.0
Setting Temperature
1 0 0 0 0
5 5
View Settings
Verifying the setting
parameters during
centrifugation
Press the
Enter button
Serial No.
Setting temperature ( -10℃ ~ 40℃)
Setting temp. limit
3 0 1
Start Stop
Setting ACC / DEC Rate
ACC (0 ~ 9 steps, Max.9)
DEC (0 ~ 9 steps, Natural DEC.0)
Saving / Calling Up a Program
Press the
Save or call button program number on
Setting Temp. Limit
Press the
Temp. limit button temperature range
Temperature range that stops operation when the temperature
is lower or higher than the set temperature.
Installation Date
Max. RPM : 50,000 rpm
Max. RCF : 254,340 xg
Automatic Rotor ID.
Identification
8.7
Lid Open
Key Lock Power Switch
Pulse
After reaching the set speed, the centrifugation
is decelated and stopped
Enter the desired Press the
Enter button
the keypad
Enter the desired Press the
Enter button
on the keypad