Fixed Refuge Position Setup - JUKI AMS-221EN Series Engineer's Manual

(2) Fixed refuge position setup

Irrespective of the second origin in the pattern data, a memory switch is available to set up the second origin
(fixed refuge position) that is common to each pattern.
When the use of the fixed refuge position has been set up with the memory switch K090, the fixed refuge
position becomes enabled, which has been set up with the fixed refuge position Coordinate X of Memory
Switch K117 and the fixed refuge position Coordinate Y of Memory Switch K118. In this state, the feeding frame
can be ready in the same position even though any pattern is used for sewing.
1. Selection of the fixed refuge position
Using the memory switch K090, it is possible to set up the fixed refuge position.
Setup
Fixed refuge position
disabled
Fixed refuge position
enabled
2. Fixed refuge position coordinates setup
Using the memory switch K117, it is possible to set up the fixed refuge position Coordi-
nate X.
Setup
Coordinate X Coordinate X of the
fixed refuge position
Using the memory switch K118, it is possible to set up the fixed refuge position Coordi-
nate Y.
Setup
Coordinate Y Coordinate Y of the
fixed refuge position
(Caution) Coordinate X is (+) when the needle position is right of the origin.
It is (-) when the needle position is left of the origin.
Coordinate Y is (+) when the needle position is behind the origin.
It is (-) when the needle position is in front of the origin.
Contents
The fixed refuge position is not used.
The fixed refuge position is used.
Contents
Coordinate X of the fixed refuge position is
set up within the feeding frame in the unit of
0.1mm.
Contents
Coordinate Y of the fixed refuge position is
set up within the feeding frame in the unit of
0.1mm.
Needle
position
Explanation
Explanation
Explanation
– 104 –