Nautilus Bowflex VeloCore Assembly And Owner's Manual page 34

Condition/Problem
Pedals loose/unit difficult to
pedal/ Pedals seem to skip or
slip with a sudden increase in
rpm
Clicking sound when pedaling
Seat post movement
Handlebar post movement
Bike will not lean
Bike will not lock in Stationary
mode
Noise/rattling from Lockout
assembly
Left and Right lean force is not
the same
Things to Check
Check pedal to crank
connection
Check crank arm to axle
connection
Check drive belt tension
Check pedal to crank
connection
Check adjustment handle
Check adjustment handle
Check Lean Lock Knob
Check Lean Lock Knob
Check Lean Lock Knob
Check bumper tension
Assembly / Owner's Manual
Pedal should be tightened securely to crank arm. Be sure connection is not
cross-threaded. Do not use if pedal is not fully tightened.
Crank arm should be tightened securely to axle.
Refer to the "Adjust the Belt Tension" procedure. Contact Customer Service
(if inside US/Canada) or your local distributor (if outside US/Canada).
Remove pedals. Make sure there is no debris on threads, and reinstall the
pedals.
Be sure the adjustment handle is securely tightened.
Be sure the adjustment handle is securely tightened.
Be sure knob is pushed completely down (unlocked position).
Be sure bike is upright. Pull the knob completely up until you hear a click.
If the Lean Lock mechanism does not click, contact Customer Service (if
inside US/Canada) or your local distributor (if outside US/Canada).
Be sure knob is pushed completely down (unlocked position).
Refer to the "Adjust the Lean Tension" procedure in the service manual.
Contact Customer Service (if inside US/Canada) or your local distributer (if
outside US/Canada).
34
Solution