Installing The Section Supply Hoses - Toro Multi Pro 1750 Installation Instructions Manual

Figure 77
1. Quick-connect fitting
(bypass manifold)
2. 90° quick-connect fitting
3. Section bypass hose—2.5
x 146 cm (1 x 57-1/2
inches)
4. Retainer (small)
2. Route the section bypass hose around the right frame
channel toward the bulkhead fitting in the sprayer tank
as shown in Figure 78.
5. Retainer (large)
6. 90° barbed fitting
7. Bulkhead fitting (sprayer
tank)
1. Section bypass hose—2.5 x 146 cm (1 x 57-1/2 inches)
3. Assemble the 90° barbed fitting of the section bypass
hose into the bulkhead fitting
4. Secure the 90° fitting to the bulkhead fitting
with the retainer (large) that you removed in step
Removing the Section Bypass Hose (page

Installing the Section Supply Hoses

1. Route the left, center, and right boom-supply hoses to
the boom-section valves as shown in
1. Left boom-supply hose—2
x 213 cm (3/4 x 83-7/8
inches)
2. Center boom-supply
hose—2 x 67 cm (3/4 x
26-5/16 inches)
2. Assemble the straight barbed fitting of the supply hose
for the left boom-supply hose onto the quick-connect
fitting at the left-boom-section valve
38
Figure 78
(Figure 77).
(Figure
16).
Figure 79.
Figure 79
3. Right boom-supply
hose—2 x 142 cm (3/4 x
55-7/8 inches)
(Figure
77)
1 of
80).