Wiring Table — Rate Valve - Toro Multi Pro 1750 Installation Instructions Manual

Figure 39
1. 4-pin adapter (rate valve)
2. Gray wire (4-pin adapter)
3. Green wire (4-pin adapter) 6. DIN harness (rate valve)
Wiring Table—Rate Valve
Wire color codes—DIN wire
harness
Not applicable
Not applicable
Brown
Blue
4. Insert the brown wire of the DIN wire harness into
the butt-splice connector on the gray wire of the 4-pin
adapter for the rate valve.
5. Center the crimping tool over the butt-splice connector
and wires and crimp the connector securely.
6. Insert the blue wire of the DIN harness and butt-splice
connector on the green wire of the 4-pin adapter for
the rate valve (Figure
7. Center the crimping tool over the butt-splice connector
and wires and crimp the connector securely.
8. Use a heat gun to shrink the insulating sleeves of the
butt-splice connectors of the wires that you installed
in steps 3 through 6.
9. Terminate the green and yellow wire of the DIN
connector as follows:
A. Cut the conductors of the green and yellow wire
flush with the insulation
4. Blue wire (DIN wire
harness)
5. Brown wire (DIN wire
harness)
Wire color codes—4-pin
adapter (rate-valve position)
Pink
Black
Gray
Green
39).
(Figure 40).
1. Green and yellow wire
(cutting the conductor)
2. Taping the end of the
green and yellow wire
B. Wrap the end of the green and yellow wire with
electrical tape to seal the wire
C. Fold the green and yellow wire to the brown wire
and blue wire and wrap the 3 wires together with
the electrical tape
20
Figure 40
3. Taping wires together
(Figure 40).
(Figure 40).