Installing The Flow Meter And Hoses; Removing The Valve Actuators - Toro Multi Pro 1750 Installation Instructions Manual

1. Bracket (agitation, rate,
and master-spray valves)
2. Bracket (section valves)
10
Installing the Flow Meter and
Hoses
Parts needed for this procedure:
1 Flow-meter hose—25 x 289 mm (1 x 11-3/8 inches)

Removing the Valve Actuators

Note: Perform this procedure if you need additional
clearance when installing the hose assemblies at the bottom
quick-connect port of the manifold valve(s).
1. With pieces of masking tape, name the position of the
valve actuator(s) as shown in
Figure 50
3. Push-in fasteners
Figure 51.
1. Rate valve actuator
2. Agitation valve actuator
3. Master spray-valve
actuator
2. Remove the retainer that secures the valve actuator to
the manifold valve and separate the actuator from the
valve (Figure 52).
Note: Retain the valve actuator and retainer for
installation in Assembling the Valve Actuator to the
Manifold Valve (page
1. Retainer
2. Manifold valve
25
Figure 51
4. Left spray-valve actuator
5. Center spray-valve
actuator
6. Left spray-valve actuator
27).
Figure 52
3. Valve actuator