Disconnecting The Optional Attachments; Disconnecting The Optional Eductor Kit - Toro Multi Pro 1750 Installation Instructions Manual

4
Disconnecting the Optional
Attachments
No Parts Required

Disconnecting the Optional Eductor Kit

1. Remove the flange clamp that secures the flanged
hose-barb of the supply hose to the inlet flange of the
eductor (Figure 9).
1. Inlet flange (eductor)
2. Gasket
2. Remove the flanged hose barb and gasket from the
eductor (Figure 9).
Note: Retain the flange clamp and gasket for
installation in 18 Installing the Supply Hose for the
Optional Eductor Kit (page
the supply hose and you will remove it with the
agitation, rate, and master spray valves in
the Agitation, Rate, and Master-Spray Valves (page
3. Remove the retainer that secures the 90° barbed fitting
of the sprayer supply hose to the T-fitting located
forward of the pressure-relief valve
Note: Retain the retainers for installation in
the Sprayer Supply Hose—Machine without the
Optional Eductor Kit (page
Figure 9
3. Flange clamp
4. Flanged-hose-barb
(supply hose)
47).You no longer need
7 Removing
(Figure 11).
Installing
34).
1. Retainer
14).
2. 90° barbed fitting (sprayer
supply hose)
3. Front of the machine
4. T-fitting
4. Remove the 90° barbed fitting from the T-fitting
(Figure 11).
9
Figure 10
Figure 11
5. Sprayer supply hose
6. Pressure-relief valve
7. 3-way valve