Parallel Setting - KStar YDC9300-RT Series Manual

4.2.5 Parallel setting

After parallel connections done, start each UPS one by one, and set the paralle ID number,
parallel amount and parallel mode respectively. The parallel ID number cannot be the same.
Parallel setting in LCD instructions as below:
1) When AC start or battery clode start, at first the main interface will appear, as Fig.1.
Welcome
10KVA
Fig.1：main interface
2) Press any button, a basic status interface appears, as Fig.2; Then press forward button or
backforward button, the main menu interface appears, as Fig.3:
Mode:On-Line
Volt:AN BN CN
Vin: 220 219 221
Vout:220
Fig.2：basic status interface
3) Press forward button or backward button, choose "setting" and press ENT to inter the setting
menu, as Fig.4; then again press forward button or backward button, choose "parallel set"
and press ENT to enter parallel setting menu, as Fig.5.
Setting
User set
System set
Parallel set
Fig.4：setting menu
4) Press ENT button to enter ID setting, as Fig.6; then press forward button or backward button
to set the ID number, for example 1,2,or 3...etc. After this seting the number, press ENT to
save this setting, as Fig.7. The paralel amount setting is the same as this ID setting.
Setting
Parallel Set
ID
P-Amount
Fig.6：parallel setting
Figure
Status
Setting
Command
Setting
Parallel Set
ID
P-Amount
Fig.5：parallel setting
Setting
Parallel Set
1 ID
2 P-Amount
Fig.7：parallel setting
Fig.3：main menu
1
2
1
2
- 16 -