Ups Setting - KStar UDC9100 Tower Series Manual

07
08
09

3-3 UPS setting

The setting fuction is controled by 3 buttons (Enter/Select,Off/up ▲, On/down▼): Enter
+Off/up ▲---goes into the setting page,Enter --- value adjustment; Off ▲ & On ▼---for choosing
different pages.
After the UPS turn ON, press buttons & ▲ for 5seconds and then goes into the setting interface
page.
Note: Figure at left corner is the page number of the setting pages.
CODE
(Operational status and
mode)
Alarm Code(Warming
Message)
All alarm codes are
present when abnormal
behavior(s) occur(s)
The charging status can
also be shown on the
screen as below while
the charger is on.
11