Ups Setting - KStar UDC9101RTS Operation Manual

3-3 UPS setting

The setting fuction is controled by 3 buttons (Func,Off/up ▲, On/down▼): Func +Off/up
▲---goes into the setting page, Func --- value adjustment; Off ▲ & On ▼---for choosing
different pages.
After the UPS turn ON, press buttons Func & ▲ for 5seconds and then goes into the
setting interface page.
Note: Figure at left corner is the page number of the setting pages.
Item
Mode setting
Press Func button to change the
setting (ECO or NOR orCF).
Press UP button ▲ to select the
previous setting.
01
Press DOWN ▼ button to select the
next setting.
Output voltage setting
Press Func button to change the
setting (200,208，220, 230, 240).
Press UP button ▲ to select the
previous setting.
02
Press DOWN ▼ button to select the
next setting.
Frequency setting
Press Func button to change the
setting (50 or 60Hz).
Press UP button ▲ to select the
03
previous setting.
Press DOWN ▼ button to select the
next setting.
Settings
11
Content Displayed