Output Mode Setting; Operation; Basic Operation - IDTECK Star RFK101 User Manual

2

Output Mode Setting

Table 1. Jumpers Setting
SW1#1
ON
ON
OFF
OFF
The default settings for SW1#1 and SW1#2 are "ON"(short circuit).
3

Operation

3.1

Basic Operation

1. Once power is applied, you can hear 3 initial beeps while the 3 LEDs turn on. Then, the
only red LED light stays on, indicating that the reader is in the standby mode after succe
ssful initialization and diagnostics.
2. Present an RF proximity card to the reader until you hear a beep sound and see the gre
en LED on. The reader will send the RF card data to the controller, then the green LED t
urns off again going back to the standby mode for the next reading.
3. 26bit Wiegand + RS232 Output Format
I. If you set the output to 26bit Wiegand + RS232 format and press numeric keys on
the keypad, you can hear a beep sound and the yellow LED turns on, which indicat
es PIN entry start. Once you enter the PIN, press "ENT" key to finish PIN entry. The y
ellow LED will turn off indicating PIN entry is finished. The reader will then send th
e PIN data to the controller.
II. In the 26bit Wiegand + RS232 output format, a facility code is within the range of
0 to 255 and an ID (PIN) is in the range of 0 to 65535. If you do not finish your PIN
entry with "ENT" key or if you do not press any key within 5 seconds, the reader wil
l make error beeps "Beep Beep Beep Beep" then clear the PIN data (no output) and
return to the standby mode. An ID (PIN) you can enter via the keypad is from 1 to
8 digits.
p.13 Operation
SW1#2 Card Output Format
ON 26bit Wiegand + RS232
OFF 26bit Wiegand + RS232
ON 26bit Wiegand + RS232
OFF 26bit Wiegand + RS232
Keypad Output Format
8bit Burst
26bit Wiegand + RS232
26bit Wiegand + RS232
4bit Burst