Table of Contents
Advertisement
Figure 19. Adding a Wi-Fi network
3. Click Add Network (1) and fill in the information as
required:
Figure 20. Wi-Fi Network Settings
Table 2. Network Information
Option
Setting
Network Name
Assign a name for the network.
SSID
Enter the exact network name.
Choose the security and key
Security Mode
encryption methods used by your
Wi-Fi network.
Smart-Vue Pro LoRaWAN Enabled Receiver
2
1
4. Click Finish Submit (2) to save your settings, then
click Save and Restart to complete configuration.
Note: Wi-Fi Network Connection Settings
All configuration to connect to your local WiFi network is set
internal to your organization. You may have a captive portal or
pre-shared key required to obtain access to your wireless
network. If this is the case, follow the internal process to
receive an exception for the LoRaWAN receiver for approval
and to maintain this connection.
Workaround for Wi-Fi
Connection with Static IP
Address
As of this writing, the Smart-Vue Pro LoRaWAN receiver does
not support the use of a static IP addresses for Wi-Fi
communications.
To use your Smart-Vue Pro LoRaWAN receiver in Wi-Fi mode
with a static IP address, you must implement a workaround
solution using an intermediary Wi-Fi repeater or router whose
setup allows a fixed IP address, as shown below, to connect
to your network.
CAUTION: The Wi-Fi router or repeater must
also support being configured as a Wi-Fi client in
order to connect to your organization's Wi-Fi
access point.
Setting Up your Receiver |
13
Advertisement
Table of Contents
