Table of Contents
Advertisement
Ensure that this information complies with your organization's
user account provisioning policies and follows best security
practices.
Rather than setting a password for the administrative
account, consider setting a pass phrase. A combination of
4 or more unrelated words with spaces is statistically more
secure than assigning a password, regardless of complexity.
Store this user-name and password information in the
designated repository defined by your organization's policies.
A digital password vault that has the ability for multiple users
is one option, while storing it in a fireproof safe is another.It is
recommended that the user-name and password should not
be stored in a location easily accessible by those not requiring
access because of the access privileges allowed to the device
with these credentials.
First-Time Setup
Setting Up Your Device Using
Setup Wizard (After Choosing
Reset and Factory Default
Settings)
When the power is turned on the device, set the device to
factory default settings to see the first-time setup. This wizard
helps you configure the main features of your device.
Here are the steps for first-time setup:
1. When the power is turned on for the first time or after you
set factory default settings, the device goes into
commissioning mode. The system requires you to set up
an admin user. Enter your user-name and click OK.
2. Enter a password for the admin user and click OK. This
password must be of sufficient length and strength (with
a mix of character classes such as letters, numbers and
symbols). Enter the password again to confirm. Click OK.
3. On the first page, you see the below screen. Click Next.
Figure 10. First Time setup wizard
Smart-Vue Pro LoRaWAN Enabled Receiver
4. Configure Call Home.
Figure 11. Call home configuration
a. This feature is not supported for the Smart-Vue Pro
solution so click Next to go to the next screen without
changing the settings.
5. Set the date, time and time zone.
Figure 12. Time configuration
a. Enter the Date.
b. Enter the Time.
c. Select the Time Zone in which the device operates.
d. Click Next.
e. By default the date and time are in UTC format. If you do
not wish to change the current settings of date and time
simply click Next to go the next screen.
6. Configure LAN network interfaces Eth0 and Br0.
Setting Up your Receiver |
7
Advertisement
Table of Contents
